3 1/4” Pultruded Fiberglass Closed Back Frame laminated with real stainable oak wood or maple wood. Completely filled with laser die cut Polystyrene, injection moulded reinforced mechanical welded corners with Polyurethane foam fill, sealed with silicone sealant and is independently tested to AAMA 101/I.S.2, CAN/CSA A440.1 and CSA A440.2 standards. Rating [CSA 440 A3/B7/C4] [AAMA HC-55].
Three 3 1/4” Fiberglass lites joined at either 30 or 45 degree angle (other angles can be specified).
Five 3 1/4” Fiberglass lites joined at either 10 or 15 degree angle (other angles can be specified).
Stock colours are White interior and exterior, White interior and Commercial Brown exterior, White interior and Sandalwood exterior. All frames use Acrythane Aqua-528 Series Intermix, which are two water based components that are urethane baked on the finish. The paint is rated environmentally friendly due to low VOC. Custom colours are available. Note that the paint finish does not wrap arounf to the bottom edge of the frame when using nail fin application. Please refer to the cross section drawing for nail fin under attachment options.
Interior connectors available in Fiberglass, Oak, or Maple. Exterior connectors available in aluminum. Bay or Bow window assembly option can come with, fir, oak laminated, maple laminated, or poplar laminated plywood seat and header and side jamb build outs (boxed). When ordering, please specify: overall width and height (including seat & head if ordering), side window flanker widths, and over all or inside projections.
Brickmoulds (with or without PVC nailing flange) are available for installation applications.
Most sizes and configurations are available. Fibertec manufactures to sizes specified + / – 1/8” (3.17 mm) industry tolerance.
Shall be performed by experienced installers in accordance with manufacturer instructions and CSA A440.4 standards. Window shall be plumb and square after installation is complete and sealed to both interior and exterior wall with high quality sealant around the perimeter of the frame. If perimeter cavity is to be foamed, additional anchorage may be required to prevent bowing. It shall be the responsibility of the installers to make all necessary final adjustments to ensure normal and smooth operation.
Occasional cleaning of glass and frame components with a non-abrasive detergent is recommended.For instructions on staining, please see our staining guide.
Products have been independently tested and rated by AAMA, and NFRC (see energy ratings).