Fibertec Steel Entry door frames mean quality and durability. We emphasize long-term performance, and our systems have achieved the highest air-tightness and energy ratings. The fiberglass foam filled frame accommodates standard size steel, fiberglass and doors. The tough resilient fiberglass frame affords security similar to steel, but will not corrode. With our state of the art technology and extensive testing, the doors will not bow, warp, crack, scratch, splinter, dent or rust as with wood or steel doors.

Other Styles: 200 Entrance Doors: Insulated Fiberglass Doors

SPECIFICATIONS

DOOR PANEL
6 1/2” The door panel is made of a pultruded fiberglass frame filled with wood reinforcement, injection moulded reinforced mechanical welded corners with Polyurethane foam fill and sealed with silicone sealant. An optional 4 1/2” Pultruded Fiberglass Frame is available for single doors only. Door slabs are 24 gauge galvanized steel skin, available in prime finish, flush or embossed pattern.
PAINT FINISH
Pultruded Fiberglass Frame uses standard White finish using Sequoia TM series V advanced acrylic polyurethane (water borne) baked on finish. Rated environmentally friendly due to low VOC. Steel door slab comes standard in primed finish ready for paint. Optional Polytex white finish is available. Custom colours are available.
SILL
The inswing door system uses a thermally broken aluminum sill, that has a strategically placed drainage system for water. The outswing door system uses a combination aluminum and oak sill with q-lon weather stripping to ensure a positive seal to the slab.
HARDWARE
Optional Multipoint lock system by Ferco, is available in polished brass, antique brass, polished chrome, brushed chrome, and oil rub. This provides added security compared to traditional lock systems. It is highly recommended to use the Multipoint lock system on all 8’ height doors.
SIZES AVAILABLE
Nominal slab sizes are 30” (certain styles only), 32”, 34”, and 36” wide by 80” height and 96” height. Fibertec manufactures to sizes specified + / – 1/8” (3.17 mm) industry tolerance.
INSTALLATION
Shall be performed by experienced installers in accordance with manufacturer instructions and CSA A440.4 standards. Window shall be plumb and square after installation is complete and sealed to both interior and exterior wall with high quality sealant around the perimeter of the frame. If perimeter cavity is to be foamed, additional anchorage may be required to prevent bowing. It shall be the responsibility of the installers to make all necessary final adjustments to ensure normal and smooth operation.
MAINTENANCE
Occasional cleaning of glass and frame components with a non-abrasive detergent is recommended.
TEST RESULTS
Products have been independently tested and rated by AAMA, and NFRC (see energy ratings).